R.H. Peterson G4-42 Manuel du propriétaire télécharger pdf (Page 7)

L-A2-256

Rev 5 - 1310220810

This safety pilot system must be installed by a qualiﬁ ed professional service technician. Instructions

must be followed carefully when installing to ensure proper performance and full beneﬁ t from the

burner system and safety pilot system.

These instructions must be used as a supplement to the instructions supplied with the R.H. Peterson burner

system. Follow the burner system instructions and make adjustments as appropriate for the addition of a safety

pilot system. Use gas pipe sealing compound that is resistant to all gasses (or Teﬂ on tape) and apply to all

male pipe connections. Make sure that all connections are tight.

The valve system is shipped pre-assembled for easy

installation onto the burner pan.

Note: Installation is easier when done outside of the

ﬁ replace.

PREPARATION

If the burner that the valve system is to be added to is

already installed; remove all decorative media, set aside to

be reinstalled later, and disconnect the ﬂ ex connector and

adapter from the burner pan (using the instructions that

came with the original burner).

CONVERTING FOR DIFFERENT GAS TYPE

CAUTION: Check to be sure this pilot kit is designed

and labeled for the type of gas (natural or

propane gas) supplied to the ﬁ replace.

The safety pilot kit may require a pilot oriﬁ ce conversion.

Replace the existing gas oriﬁ ce with the opposite gas

oriﬁ ce (contained in the envelope marked "L.P. GAS" or

"NAT GAS") by carefully removing the pilot gas supply line.

Re-attach the pilot gas supply line to the pilot when done.

Reference Fig. 7-1.

CAUTION: During any conversions, all components must

be set/converted for the appropriate gas type

(i.e. burner oriﬁ ce, regulator, etc.). Contact

your dealer and a qualified professional

service technician.

INSTALL VALVE

1. Apply gas pipe sealing compound (or Teﬂ on tape) to the

male end of the fuel injector or air mixer on the burner.

2. Install the valve to the fuel injector or air mixer by

screwing the pan into the valve (Fig. 7-2). Take care not

to damage the attached pilot assembly when rotating

the burner pan. Be sure all connections are tight.

Important: Ensure the valve is positioned parallel with the

ﬁ replace ﬂ oor. Adjust as necessary.

INSTALLATION

Fig. 7-1 Pilot conversion (only if applicable)

Burner

pan

Fuel injector

or air mixer

Valve

Attach the valve to the

air mixer/fuel injector by

rotating the burner pan.

Install shown on

a G45 pan

Fig. 7-2 Install valve

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

R.H. Peterson G4-42 Manuel du propriétaire Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers R.H. Peterson G4-42